Before taking off, make sure the drone is in a horizontal position and the battery is fully charged. Turn on the power to the remote or ground control station and wait a few seconds for the drone to sense the signal.
Click the take-off button on the left side of the APP, long press the pop-up window, and the aircraft will realize automatic take-off. After takeoff, the button on the left side of the APP will become the landing icon. Click the landing button on the left side and long press the popup window to realize automatic landing. If you need to take off manually, (the APP will prompt you to check whether the blade is installed correctly when you break the lever for the first time each time you start the machine.) Take the American hand as an example, please pull down the two remote rods at the same time to the bottom and then move them inward (outward). After the blade rotates, gently push the throttle lever upward with your left hand to realize manual take-off. The rocker on the left of the remote control is used to control the flight height and nose orientation, and the rocker on the right is used to control the forward, backward and left and right flight of the aircraft; When the motor is started, if the aircraft does not take off, pull down the left rocker, the motor of the aircraft will be closed, if the aircraft has taken off, pull down the left rocker, the aircraft will land. Press the emergency stop button on the remote control, and the aircraft will brake and hover in an emergency. Information such as the current flight distance and speed can be seen at the lower left of the APP interface. Please always keep the antenna of the remote control aligned with the direction of the aircraft during flight. (When the GPS signal is poor or the compass is interfered with, the aircraft will enter the attitude mode, and the aircraft cannot hover at a fixed point and brake autonomously. Need to land the vehicle as soon as possible) or better communication quality.
