To connect your DJI remote control to your drone , follow these steps:
Ensure that the DJI drone is fully charged, the remote control is turned on and fully charged, and the two are within the range of mutual visibility.
Turn on DJI drone and remote control.
Stretch the antenna of the remote control and the drone.
Press the power button on the back of the drone, wait for the self-test of the drone to be completed, and the prompt sound will start.
Press and hold the power button on the remote control and wait for the remote control to turn on.
Switch the flight mode in the lower left corner of the remote control to P(Positioning), and wait for the remote control to connect to the drone successfully. During the connection process, the remote control should be kept within the range of mutual visibility with the drone. If the remote control fails to connect, you can press and hold the "Link" button in the upper left corner of the remote control to reconnect. When the remote control is low, it needs to be charged in time, otherwise it may cause unstable connection or failure.
In addition, you can also connect through the following steps:
Press and hold the power button of the remote control for more than 3 seconds until the light of the remote control turns orange and flashes, then insert the connection cable between the remote control and the drone into the connection hole on the drone, and wait a few seconds for the remote control and the drone to connect successfully. After the connection is successful, the indicator light of the remote control will turn green, and the remote control and the drone have been successfully paired.
After the aircraft and remote control are turned on, run DJI Fly or DJI GO 4 APP. In the camera interface, click the icon to enter the control interface, and click "Repair (frequency matching)". In the process of frequency, remote control status indicator light blue flashing, and issue a "di - di..." A prompt tone is played. Long press the aircraft power button for more than 4 seconds, enter the frequency after the aircraft battery power indicator light cycle flashing, and emit a "beep" prompt sound. After the frequency is successful, the remote control makes two "beep" sound, and the status indicator is green and on.
