Boot: short press to see the power, short press and then long press to boot
Taking the mavic air 2 as an example, when the aircraft battery is pressed once, the light on the battery button will light up, four lights indicate almost full power, two lights indicate nearly half power, and so on. After confirming that the power is above three lights, install the battery in the aircraft battery compartment, confirm that the buckle is locked, press the battery power button and then press the battery power button, and hear the aircraft boot tone. It should be noted that do not move the body during the boot process.
Taking off: Properly holding the remote control in both hands is the first step to start flying, you need to press your thumb over the stick and not leave the stick during the flight. Place the index finger on the button and the dial wheel above the remote control, and hold the rest of the fingers firmly on the back of the remote control.
Manual take-off: Use the splay lever to unlock the motor. The specific method is to tilt the left and right rocker at the same time to the inside or outside 45 degrees to the limit area, the drone motor starts, the left and right rocker slowly back to the center, the left rocker directly push up about one-third of the rod, and visually take off the drone to a height of more than 2m, confirm that it is higher than the human head, ready to operate.
Automatic takeoff: Click the automatic takeoff button on the left side of the screen, and long press the takeoff button in the center of the screen for about 3 seconds. The UAV will automatically take off to a height of about 1.2 meters, and then push the left joker upward for about one-third of the bar, and visually hover the UAV above the height of the head, ready for operation.
